How to jailbreak iOS 6.0.1

iOS 6.0.1 was just released a few minutes ago, but we’ve already confirmed it can bejailbroken right now using the existing jailbreak tools for iOS 6.

Although RedSn0w was recently updated to 0.9.15b3, the update doesn’t yet include support for iOS 6. That’s okay, because you can still point at the already supported iOS 6 firmware and successfully jailbreak iOS 6.0.1.

Check inside for the full video walkthrough that shows how.

Note: This is a tethered jailbreak for pre-A5 devices (iPhone 4, iPhone 3GS, iPod touch 4th generation) only.

Step 1: Download RedSn0w 0.9.15b3 and iOS 6.0 for your specific device from ourDownloads page.

Step 2: Connect your device to your computer and place it into DFU mode.

Step 3: Open RedSn0w, and ensure it detects your device.

Step 4: Click Extras > Select IPSW, and select the iOS 6.0 firmware for your device. It should successfully identify the build.

Step 5: Go back to the main RedSn0w page and click Jailbreak. RedSn0w will process, and then allow you to install Cydia, which should be already checked on the next screen. Click Next, and the jailbreak will finish processing and begin on your iPhone. Keep RedSn0w open.

Step 6: Once the jailbreak is complete and you are back on your device’s Lock screen, place your device back into DFU mode.

Step 7: On the main page of RedSn0w click Extras > Just boot. This will perform a tethered boot. Your device should reboot with a pineapple logo.

Step 8: Once the device reboots, you should see Cydia on the Home screen.

That’s it, you’re finished! For more info on RedSn0w be sure to check out our dedicated RedSn0w page.

Were you able to successfully jailbreak? Share your experience in the comments section below.